JBM 53880, Инструкция по эксплуатации

Страница: 6 / 45

· 6 ·
REF. 53880
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
INSTRUCTION MANUAL
EN
SAFETY INSTRUCTIONS
• Read and understand the entire instructions manual be-
fore using the pallet truck.
• Do not load pallet truck beyond rated capacity (2500 ki-
lograms).
• Secure load before transporting.
• Keep the load centered on the pallet.
• Do not operate loaded pallet truck on ramps or inclines.
• Always wear appropriate safety shoes.
• Never leave a loaded pallet truck unattended in the raised
position; always lower load to the floor.
ASSEMBLY
Tools need for assembly:
• Hammer
• Flat screwdriver
• 14mm wrench
To attach handle assembly to the frame
1
WARNING!
Verify that spring safety pin is in
place.
The pin should be well rested in the
holes situated on each side of the
pump housing.
If the safety pin is not rested proper-
ly in one of the holes, put pressure
on the spring using a “C” clamp
pushing down on the pump stem.
Once pressure is relieved on the
pin, reinsert properly and remove
clamp slowly.
2
Insert handle pin through the holes.
Using a hammer, drive in one spring
pin on one side only.
3
Verify that the center hole is facing
you.
4
It handle pin’s center hole is facing
away from you, insert pin again
and make sure pin’s center hole is
facing you.
IMPORTANT!
The up/down lever’s chain passes
through this center hole.
If left this way, the chain will have
an “S” form and be under too much
tension, making the up/down lever
difficult to use accurately.
5
IMPORTANT!
Before this step, make sure to feed
the chain on the outside of the
piston seat.
If left in its proper position, it will not
be possible to insert the handle pin
and chain, breakage may occur.
Align handle holes with pump
housing holes and push through
handle pin.
6
Make sure that handle pin is
completely through the handle and
resting on the other side.
7
Pull down on the handle to release
the tension on the safety pin.
Carefully remove the safety pin.
8
Feed the chain and nut inside the
handle and through the handle pin’s
center hole.
IMPORTANT!
Put the up/down lever to its lowest
position to make the process easier.