background image

EN-3

Warning

Mains plug/appliance coupler is used to 

disconnect device and it shall remain readily 

operable.

Safety Compliance

This equipment has been designed to meet the 

IEC/EN 62368-1 international electrical safety 

standard.

This device complies with Part 15 of the FCC 

Rules. Operation is subject to the following two 

conditions:

1.  This device may not cause harmful 

interference, and

2.  This device must accept any interference 

received, including interference that may 

cause undesired operation.

The building installation shall be regarded as 

providing protection in accordance with the rating 

of the wall socket outlet.

Caution On Installation

For proper heat dispersal, do not install this unit in 

a confined space, such as a bookcase or similar 

enclosure.

 

…

More than 0.3m (12in) is recommended.

 

…

Do not place any other equipment on this unit.

Wall

z

z

z

Wall

z

FCC Information  

(For US Customers)

PRODUCT

This product complies with Part 15 of the FCC 

Rules. Operation is subject to the following two 

conditions:

1.  This device may not cause harmful 

interference, and

2.  This device must accept any interference 

received, including interference that may 

cause undesired operation.

IMPORTANT NOTICE: DO NOT MODIFY THIS 

PRODUCT

This product, when installed as indicated in the 

instructions contained in this manual, meets 

FCC requirements. Modification not expressly 

approved by JBL may void your authority, granted 

by the FCC, to use the product.

NOTE

This product has been tested and found to 

comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable 

protection against harmful interference in a 

residential installation.

This product generates, uses and can radiate 

radio frequency energy and, if not installed 

and used in accordance with the instructions, 

may cause harmful interference to radio 

communications.

However, there is no guarantee that interference 

will not occur in a particular installation. If this 

product does cause harmful interference to radio 

or television reception, which can be determined 

by turning the product OFF and ON, the user is 

encouraged to try to correct the interference by 

one or more of the following measures:

 

…

Reorient or relocate the receiving antenna.

 

…

Increase the separation between the equipment 

and receiver.

 

…

Connect the product into an outlet on a circuit 

different from that to which the receiver is 

connected

 

…

Consult the local retailer authorized to distribute 

this type of product or an experienced radio/TV 

technician for help

Safety Information  

(For European Customers)

 

…

Avoid high temperatures. Allow for sufficient 

heat dispersion when installed in a rack.

 

…

Handle the power cord carefully. Hold the plug 

when unplugging the cord.

 

…

Keep the unit free from moisture, water, and 

dust.

 

…

Unplug the power cord when not using the unit 

for long periods of time.

 

…

Do not obstruct the ventilation holes.

 

…

Do not let foreign objects into the unit.

 

…

Do not let insecticides, benzene, and thinner 

come in contact with the unit.

 

…

Never disassemble or modify the unit in any 

way.

 

…

Ventilation should not be impeded by covering 

the ventilation openings with items, such as 

newspapers, tablecloths or curtains.

 

…

Naked flame sources such as lighted candles 

should not be placed on the unit.

 

…

Observe and follow local regulations regarding 

battery disposal.

 

…

Do not expose the unit to dripping or splashing 

fluids.

 

…

Do not place objects filled with liquids, such as 

vases, on the unit.

 

…

Do not handle the mains cord with wet hands.

 

…

When the switch is in the OFF position, the 

equipment is not completely switched off from 

MAINS.

 

…

The equipment shall be installed near the 

power supply so that the power supply is easily 

accessible.

A Note About Recycling

This product’s packaging materials are recyclable 

and can be reused. Please dispose of any 

materials in accordance with the local recycling 

regulations.
When discarding the unit, comply with local rules 

or regulations.
Batteries should never be thrown away or 

incinerated but disposed of in accordance with the 

local regulations concerning battery disposal.
This product and the supplied accessories, 

excluding the batteries, constitute the applicable 

product according to the WEEE directive

Correct Disposal Of This Product

These markings indicate that this product should 

not be disposed with other household waste 

throughout the EU.

Pb

To prevent possible harm to the environment or 

human health from uncontrolled waste disposal 

and to conserve material resources, this product 

should be recycled responsibly.
To dispose of your product, please use your 

local return and collection systems or contact the 

retailer where the product was purchased.

Содержание SA750























Отзывы: