Page 4
INTONATO
DC Operation Manual
Overview
Overview
1. HiQnet
®
Port
This RJ45 port provides power and
network connectivity to the Intonato
DC. PoE (Power over Ethernet) is
required to power the Intonato DC
controller via this port. If connecting to
a network router or switch that does
not provide PoE, an inline PoE power
supply must be used. See
“Supplying
Power to the Intonato DC” on page
6
for more information.
NOTE:
A DHCP server is required on the network to assign the Intonato DC an IP address.
2. LCD & OPTION Buttons
When performing certain Intonato DC functions, such as muting or soloing specific speaker
outputs or recalling scenes, options will appear in the LCD and the corresponding
OPTION
buttons are used to make selections. Additionally, when the
SCENE
button is illuminated, the
OPTION
buttons may be held to modify the order of scenes in the display.
3. PREV & NEXT Buttons
Pressing these buttons will navigate to the next or previous screen of available options in the LCD,
where applicable. The
PREV
and
NEXT
button LEDs will light when other screens of options are
available for selection.
4. Recessed Button
Press and hold this recessed button upon power-up to enter the Boot menu. See
“Using the Boot
Menu” on page 19
for more information.
5. ROTARY (VOLUME) Control
Adjusting this rotary control will attenuate the volume of all Intonato 24 output channels configured
for master volume control. This control adjusts volume in the following increments:
• The top 30 dB range is adjusted in 0.5 dB increments
• The next 30 dB down is adjusted in 1 dB increments
• The remaining lower range is adjusted in 5 dB increments
NOTE:
When the Volume encoder is turned quickly, control incrementation will be accelerated.
This allows for precise volume control when turning the encoder slowly, or large (yet smooth)
jumps in volume control when turning the encoder quickly.
-21.0dB
Aux: -9dB
Solo: Off
Mute: Off
CLK:
Internal
CLK:
48000Hz
Status: Ok
2
5
7
8
9
6
4
1
11
12
13
10
3
