JBL EVOi.net, Руководство пользователя

Страница: 12 / 36

EVOi.net
10
I N S T A L L A T I O N S / S E T U P
STARTING UP (continued)
Testing the System
At the beginning of or anytime during a system setup, the
hookup configuration of the EVO loudspeaker can be tested
by using the
TEST button.
This button is used to control the user audio test mode, i.e.
pressing it will produce ‘pink noise’ output from each EVO
loudspeaker.
The first press of the TEST button will…
1. Enable the Test Mode.
2. Illuminate the orange TEST LED.
3. Cause the first found EVO loudspeaker to transmit
‘Pink Noise’.
4. Flash the relevant Speaker Status Green OKAY LED to
indicate the Limpet transmitting.
Successive presses of the TEST button will…
1. Move the ‘Pink Noise’ to the next EVO loudspeaker.
2. Indicate the ‘New Transmitting’ EVO loudspeaker by
flashing the relevant Speaker Status Green OKAY
LED.
When all attached EVO loudspeakers have been tested, the
next press of the
TEST button will exit Test Mode and
extinguish the TEST LED. There is a short delay between
pressing the TEST button for the last time and returning all
speakers to normal operation.
EQ SELECT SETTINGS AUTO EQ SETTING
MUSIC I
MUSIC II
SPEECH
NEUTRAL
LOCKED EQ SET
TEST AEQ ON
MAIN OUT
SETUP 1&2
EQ SET
AUX OUT
SETUP 3&4
HOLD TO CLEAR MAIN HOLD TO CLEAR MAIN
If the
LOCK
switch is engaged at any time during Test
Mode, Test Mode will immediately end. The
TEST
indicator LED will be extinguished and any EVO loud-
speakers will stop transmitting ‘Pink Noise’.
Figure 9