background image

SPECIFICATIONS 

© 2005 Harman International Industries, Incorporated 

JBL is a registered trademark of Harman International Industries, Incorporated.

Part No.406-000-05178

PRO SOUND COMES HOME

JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 

8500 Balboa Boulevard, Northridge, CA 91329

www.jbl.com   

*Trademarks of Dolby Laboratories.

DTS is a registered trademark of Digital Theater Systems, Inc.

All features and specifications are subject to change without notice.

BALBOA SUB

Amplifier Power (RMS):

100 Watts

Peak Dynamic Power 

:

225 Watts

Driver:

200mm (8") Pure-cellulose-fiber cone

Inputs:

Line-level, LFE and  
speaker-level with
5-way binding posts

Low-Pass Frequency:

Variable from 50Hz to 150Hz

Frequency Response:

35Hz – Low-pass 
crossover setting (–6dB)

Dimensions (including feet)
(H x W x D):

413mm x 279mm x 349mm

Weight:

13.6kg

The Peak Dynamic Power is measured by record-
ing the highest center-to-peak voltage measured
across the output of a resistive load equal to mini-
mum impedance of the transducer, using a 50Hz
sine wave burst, 3 cycles on, 17 cycles off.

Declaration of Conformity

We, Harman Consumer Group International

2, route de Tours 
72500 Chateau-du-Loir
France

declare in own responsibility that the product described
in this owner’s manual is in compliance with technical
standards: 

EN 55013:2001+A1:2003 
EN 55020:2002+A1:2003 
EN 61000-3-2:2000 
EN 61000-3-3:1995+A1:2001
EN 60065:2002

Gary Mardell

Harman Consumer Group International

Chateau-du-Loir, France  1/05

Содержание Balboa SUB/230









Отзывы: