jbc pulsmatic, Руководство пользователя

Страница: 4 / 16

BE-SA
ENGLISH
1 Remove the ring to disengage the tip.
2
Remove the tip by pulling the soldering iron
backwards.
3 Insert the new tip and make sure it has gone
all the way in.
JBC reserves the right to make technical changes without prior
notification.
SOLDER REEL HOLDER
For production-line purposes we recommend
using our holder BE-SA, which enables solder
reels in sizes up to 2.5 kg to be used. Simply
wrap a couple of turns of the solder wire
around an empty reel as shown.
TIP CARE
- Unplug the soldering iron.
- To clean the tips, use the damp sponge in-
cluded with the JBC stand. Only deionised
water (car battery watter) should be used
in order to wet the sponge. If normal water
was to be used, it is very likely that the tip
will become dirty due to the salts dissolved
within the water.
- Do not file the tips or use abrasive tools which
may damage the tip’s protective surface
coating and avoid knocking them about.
- If the tip has been a long time with-
out being tinned, use the metal brush
Ref. 0297705 adaptable to the support, to
remove any dirt and oxide.
REPLACING THE TIP
Use the tip extractor Ref.0114108, and
proceed as shown in these diagrams.
2