ENGLISH
USER MANUAL
JB SYSTEMS
®
3/10
SUNBAR COMBI
DESCRIPTION:
1. SAFETY EYE:
used to attach a safety cable when the unit is rigged, se
e paragraph “overhead rigging”
2. MAINS INPUT:
connect the included mains cable here. You can also use any power cord with a
PowerCon connector.
3. DMX INPUT:
3pin male XLR-connector used to connect the projector with the DMX controller or with the
previous unit in the DMX chain.
4. M-DMX INPUT:
Please note that this USB-connector is NOT used for updates or to connect the unit to a
PC! Instead this USB-connector makes it very easy to add wireless DMX to the unit! Just add the
(optional) WTR-DMX DONGLE from BRITEQ
®
and you will get wireless DMX! Moreover you will be able
to connect other DMX-controlled equipment to the DMX-output so you can share the wireless DMX
function with all connected units! No extra settings to be made in the setup menu, just follow the
procedure in the user manual supplied with the WTR-DMX DONGLE from BRITEQ
®
. The separate
WTR-DMX DONGLE is available from WWW.BRITEQ-LIGHTING.COM (order code: 4645)
5. MICROPHONE:
is used to trigger the sound controlled functions and programs
6. DISPLAY
shows the various menus and the selected functions.
7. DMX OUTPUT:
3pin female XLR-connector used to connect the projector with the next unit in the DMX
chain.
8. MAINS OUTPUT:
you can use this output to power the mains input of the next unit in the DMX chain (for
easier linking up to 10A). You can also use a Combi Cable to link power and DMX signal with one cable
9. FUSE HOLDER:
Important: Always replace the fuse by a model with exactly the same specifications !
10. GROUND CONNECTOR:
if extra grounding is required, the connection can be done here
11. MENU button:
used to browse the different functions in the menu
12. UP button:
to increase the values shown on the display.
13. DOWN button:
to lower the values shown on the display.
14. ENTER button:
used to confirm your choice or to enter the setup mode of a function
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
•
Before rigging make sure that the installation area can hold a minimum point load of 10times the device’s
weight.
•
Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.