ENGLISH
USER MANUAL
JB SYSTEMS®
12/12
EZ-CON 192
•
[FIXTURES] 1-8 button (1). Only the first 8 buttons can be used.
The display shows [usbload1]
… [usbload8] depending on the chosen fixture number.
Repeat the above steps a and c to load the data into the 8 memory banks.
During loading the data, the green LED [SAVE/LOAD] (4) will light up. Once the data is loaded, the
EZ-CON 192 will return to its normal working mode.
Note :
When the yellow LED [ERROR] (3) lights up, the message [usberror] will appear on the
display (12) indicating there has an error occurred during the loading procedure.
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should
be cleaned monthly.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates:
damp, smoky or particularly dirty surroundings can cause gr
eater accumulation of dirt on the unit’s
optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 30 days.
•
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
This unit is radio-interference suppressed. This product meets the requirements of the current European
and national guidelines. Conformity has been established and the relevant statements and documents
have been deposited by the manufacturer.
Power Input:
AC 110 ~ 240V 50/60Hz
Fuse:
F1A (5x20mm)
DMX outputs:
3pin XLR;
DMX, channels 001
→
192
USB A-port for M-DMX (optional dongle)
Midi input:
5pin Din
Audio input:
RCA 0.1V ~ 1Vpp
Size:
52.7 x 19.2 x 8.7cm (19
”
/ 3U without cover)
Weight:
2.7kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website:
