ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
6/8
CAM-SPOT 50TW
•
Use [UP]/[DOWN] buttons to select [YES / NO]
•
Press the [ENTER] button to confirm.
Default factory settings:
PARAMETER name
Defaults
factory
DMX address
001
DMX Mode
2.2CH
Mas/Slav
Slave
Strobe
0
DMX Fail
[Hold]
DimMode
[OFF]
Manual Dimmer
100
CCT preset
69
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Master / Slave mode:
Connect the projectors together as shown on the drawing. Please refer to the paragraph “SETUP MENU” to
setup the master. All slaves must be set to SLAVE-mode.
IMPORTANT: make sure that no DMX-controller is connected, this will result in unexpected behavior!
Electrical installation for two or more units in DMX-mode:
•
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX controller and all the connected units.
•
Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
•
To prevent strange behavior of the light effects, due to interferences, you must use a
90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this simply
won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode.
