JB-Lighting P18, Руководство по эксплуатации, Страница: 27 / 32

- 27 -
P18
Apertures 1a, 1b, 2a, 2b, 3a, 3b, 4a, 4b:
The individual apertures are calibrated ex works to ensure that the opposite apertures of all delivered
P18s are just about closed at values of DMX 127.5. For further details please contact your dealer or
JB-Lighting service department.
RECEIVESOFT
This area can be used to import the software of the P18 (see 7.5 Software Update on page 29).
7.2 Changing gobos
To open the device (from the right side) place
the spotlight on a firm base as shown in the picture,
the display (1) facing you, the tilt lock (2) is on the right
side and the spotlight head facing away from you
(3) (Or look through the grille into the spotlight from
behind and look at the arrow showing the cover to
be opened).
To lift off the cover, open the four camlocks (4) by
half a turn, lift off the cover and unhook the safety
lanyard. Now open the two knurled screws (5) and
remove the gobo insert. The following figure (1)
shows the gobo insert of the P18.
1
2
3
4
5
To change the rotating gobos, press the entire silver gobo
holder on the outside of the wheel slightly downwards
(Fig. 2) and remove the entire gobo holder. Turn the gobo
holder (Fig. 3) over and remove the clamping ring A. You
can then replace the gobo and replace the ring. To change
the fixed gobo (Fig. 4), remove the clamping ring with a
pointed object and remove the gobo from the holder. Then
place the new gobo in the holder and secure the gobo again
with the clamping ring (A). When inserting glass gobos,
ensure that the coated side is facing the lens. Gobos that
must not twist, e.g. logos, should be additionally secured
against twisting with a drop of silicone adhesive.
(1)
(2) (3)
A
(4)
A