JB-Lighting P18, Руководство по эксплуатации, Страница: 14 / 32

- 14 -
P18
5.2 FACTORY DEFAULTS - Factory settings
To reset P18 to the factory settings, go to the menu item FACTORY DEFAULTS, LOAD DEFAULTS.
After confirming the security prompt SURE? with “ENTER”, all parameters are reset to the factory
settings.
5.3 USER DEFAULTS - User settings
If the user has set the P18 in the PERSONALITY menu to their personal settings, these can
be saved and loaded in the USER DEFAULTS menu. In order to prevent unintentional alteration
of the data, you must enter the following password during the saving process: “JB-LIGHTING”.
5.4 DMX ADDRESS - DMX addressing
DMX addressing can be carried out directly in the display. Set the desired DMX address by pressing
the “UP” or “DOWN” key. The value is confirmed with the “ENTER” key. DMX addressing can
also be carried out within the menu under DMX ADDRESS.
5.5 PERSONALITY - Personal settings
DMX INPUT MODE
A LumenRadio radio DMX receiver module is installed in the P18 at the factory. To use
this in combination with a LumenRadio transmitter, the menu item WIRED (factory setting) can
be switched to WIRED/WIRELESS. For the receiver's login to the transmitter, please refer to
the transmitter's operating instructions. If the device has logged in, the corresponding radio
channel is displayed. A level indicator in the display informs about the current reception quality.
If the P18 is additionally connected via the DMX/etherCON sockets, this signal has priority over
the radio link.
DMX MODE
The P18 has 2 operating modes (see channel assignment page 18). All parameters of P18
can be operated via mode 1. However, all channels (except pan/tilt) are controlled with 8
bits. By selecting Mode 2 - 16 Bit the gobo, prism rotation, CMY/CTO, dimmer, focus, zoom,
the complete shutter slide unit as well as pan/tilt are controlled via 16 Bit.
PAN/TILT
The motion resolution can be changed from 16 bits to 8 bits under RESOLUTION. In the factory
setting, this is set to 16 bits. In 8-bit resolution, the P18 can be positioned less precisely, but can
be operated more rapidly depending on the lighting console. The menu items PAN INVERSE and
TILT INVERSE allow you to invert the direction of movement. Under PAN/TILT SWAP, the “Pan”
and “Tilt” channels can be interchanged.
CURVES
The dimmer curve can be changed from exponential (square) to linear. The “exponential” dimmer
curve (factory setting) causes the dimmer to fade in and out more smoothly.
SHORTEST DISTANCE
This menu item addresses both the colour wheel channel and the gobo wheel channels. In the
factory setting (ON), the colours/gobos change with each other over the shortest distance.
Switching to OFF causes the colour/gobo to change only in the order specified by the wheels.