Take off/
Landing
Emergency
Stop
6
FLYING
REMOTE LINK & CALIBRATION
Step 1
Take out the Stand Base and assemble them, forming a
displaying stand.
Step 2
Take out the figure and affix it at the bottom of the drone.
Step 3
After the figure is installed, place the drone and the figure on
the displaying stand. Please note that the black receiving
head at the bottom of the drone should fit into the displaying
stand hole. The figure should be standing flat on its feet,
facing the stand. This will help keep the drone level on the
stand; ready for takeoff. To fly the drone without the figure,
start by placing the drone on a flat surface.
Step 4
Power on the drone, the drone’s LED lights will blink as it
searches for a signal from the remote. Make sure the drone is
on a flat surface. If not, it needs to adjust the drone and the
displaying stand until the drone is on a flat surface.
Drone and pilot should face the same direction.
Step 5
Power on the remote, the remote’s LED light will blink. Push
the Left Control Stick fully forward, wait for a chime to sound,
then pull the stick fully rearward, and wait for a second chime.
When the LED lights of the drone and remote turn solid, the
drone and remote are paired and get ready to fly.
Step 6
After the drone and remote are paired, pull-down, and
inwards on both control sticks for 2-3 seconds. When the
LED lights have stopped blinking and turn solid, the
calibration is completed, and the drone is ready to fly. (If the
LED lights blink all the time, the drone may not be placed on
a flat surface, and calibration cannot be completed.)
Step 7
After calibration, press ”Take off” button, the drone will take
off to a certain height automatically. Refer to the below “Flight
Controls” to enjoy the flight. When you need to stop flying,
press the “Landing” button, and the drone will automatically
slow down. When the figure lands and the drone tilts to a
certain angle, it will automatically stop rotating. (Please press
the “Emergency Stop” button to stop the drone operation in
case of emergency).
Before flying, the drone and the remote must be linked together and the gyroscopes on the drone must be
allowed to calibrate.
Built-in non-replaceable 3.7V rechargeable battery.