page 8
www.jayline.co.nz
NOVEMBER 2016
WARNINGS
1.
WARNING:
THE HEATER AND FLUE SYSTEM SHALL BE INSTALLED IN ACCORDANCE
WITH AS/NZS 2918:2001 AND THE APPROPRIATE REQUIREMENTS OF THE RELEVANT
BUILDING CODE OR CODES.
2.
WARNING:
APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD SHALL
COMPLY WITH THE REQUIREMENTS OF AS/NZS 4013:2014 AND/OR CM1 WHERE REQUIRED
BY THE REGULATORY AUTHORITY, I.E. THE APPLIANCE SHALL BE IDENTIFIABLE BY A
COMPLIANCE PLATE WITH THE MARKING ‘TESTED TO AS/NZS 4013:2014 AND/OR CM1.
ANY MODIFICATION OF THE HEATER THAT HAS NOT BEEN APPROVED IN WRITING BY THE
TESTING AUTHORITY IS CONSIDERED TO BE IN BREACH OF THE APPROVAL GRANTED FOR
COMPLIANCE WITH AS/NZS 4013:2014 AND/OR CM1.
3. PLEASE ENSURE THAT ONLY COMPONENTS APPROVED BY WALLTHERM AIR® ARE USED
FOR THE INSTALLATION AS SUBSTITUTES MAY ADVERSELY AFFECT PERFORMANCE AND
MIGHT NULLIFY COMPLIANCE WITH THE REQUIREMENTS OF AS/NZS 2918:2001.
CAUTION:
MIXING OF HEATER OR FLUE SYSTEM COMPONENTS FROM DIFFERENT
SOURCES OR MODIFYING THE DIMENSIONAL SPECIFICATION OF COMPONENTS MAY
RESULT IN HAZARDOUS CONDITIONS. WHERE SUCH ACTION IS CONSIDERED, THE
MANUFACTURER SHOULD BE CONSULTED IN THE FIRST INSTANCE.
4.
CAUTION:
CRACKED AND BROKEN COMPONENTS, E.G. GLASS PANELS OR CERAMIC
BRICKS MAY RENDER THE INSTALLATION UNSAFE.
ANY VARIATION FROM THESE INSTALLATION INSTRUCTIONS OR ANY DOUBTS ABOUT THEM
MUST BE CHECKED AGAINST THE REQUIREMENTS OF THE AS/NZS 2918:2001.
5.
CAUTION:
THE ELECTRICAL CONNECTION FOR THE FAN MUST BE PERMANENTLY
CONNECTED, EARTHED AND FITTED WITH AN ISOLATING SWITCH. THE ELECTRICAL
INSTALLATION REQUIRES A (COC) CERTIFICATE OF COMPLIANCE, OBTAINED FROM
THE ELECTRICIAN.
6.
CAUTION:
THE FAN SPEED AND TEMPERATURE ARE FACTORY SET AND CANNOT BE
ADJUSTED. THE FAN MUST REMAIN SWITCHED ON DURING USE.
7. THE APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND
KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION.
8. CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE
APPLIANCE.
9. MEANS FOR DISCONNECTION MUST BE INCORPORATED IN THE FIXED WIRING IN
ACCORDANCE WITH AS/NZS WIRING RULES.
10. IF THE CORD IS DAMAGED, IT MUST BE REPLACED BY THE MANUFACTURER, ITS SERVICE
AGENT, OR SIMILARLY QUALIFIED PERSONS TO AVOID A HAZARD.
Содержание WALLTHERM AIR
Страница 22: ...page 22 www jayline co nz NOVEMBER 2016...
