Jayco Select Jay Series, Руководство пользователя

Страница: 41 / 101

To use the city water fill
1. If needed, sanitize the water system.
2. Remove the connection cap and attach a
garden hose to the inlet.
3. Turn ON the water at the water source.
4. Enter the RV and open the cold water
supply faucets to bleed air from the water
lines.
5. The water heater will fill first, followed by
the supply lines and faucets.
When the water lines are nearly full, you
may experience some “air pockets.” Allow
them to escape before closing the cold
water supply faucets.
The fresh water connection should be
unplugged (i.e., the garden hose
disconnected) when the RV is left
unattended for any amount of time. If
something would happen to the water
system, this may help limit water damage
to a smaller area.
To disconnect the city water fill
6. Shut OFF the water at the water source.
7. Disconnect the garden hose and reinstall
the connection cap.
To reduce the chance of contamination,
prevent the garden hose from coming into
contact with the ground. Reinstall the
connection cap when the fresh water
connection is not being used. Do not remove
the following label from your RV:
Dry camping
You can gravity fill the fresh water system if
you do not have access to city water; however,
allow extra time to fill the fresh water system if
you are using this method. Follow the steps
listed above; however, at step 3 put the other
end of the garden hose into your container of
fresh water, and at step 4 turn ON the water
pump (instead of turning ON the water at the
water source.) When the fresh water tank is
full, shut OFF the water pump and disconnect
the garden hose as discussed in step 8.
W
ATER
P
RESSURE
R
EGULATOR
(C
USTOMER
S
UPPLIED
)
Excessive pressure from water supply
systems may be encountered in some parks,
especially in mountain regions. Water
pressure regulators are available to protect
your system against such high pressure. A
regulator of this type is recommended to
prevent damage to the plumbing system or
components. Water pressure regulators
(customer supplied) are available from your
RV dealer to protect the RV plumbing system
against such high pressure.
12-
VOLT
W
ATER
P
UMP
& S
WITCH
(I
F
S
O
E
QUIPPED
)
Once activated, the water pump (also known
as the demand pump) will self-prime, and
provide water. The water pump continues to
run until approximately 45 lbs. of pressure is
achieved and shut off. The water pump will
automatically re-start when pressure drops.
Some cycling may occur, depending on the
volume of water being released. The water
pump is engineered by the OEM with a check
valve to prevent water from back flowing into
the fresh water supply tank
36
SECTION 5
PLUMBING SYSTEM
WARNING
POTABLE WATER ONLY. SANITIZE,
FLUSH AND DRAIN BEFORE USING.
SEE INSTRUCTION MANUAL.
FAILURE TO COMPLY COULD
RESULT IN DEATH OR SERIOUS
INJURY.
AD-04
Fig. 5.2 Potable water only label
CAUTION
Not using a water pressure regulator when
using city water may cause the o-rings to
blow. To prevent damage to the plumbing
system or components when using the city
water connection, a 45 lb. (315 KPa) rated
water pressure regulator is recommended.