Jayco Precept 2018, Руководство пользователя

Страница: 125 / 169

123
Section 8: Plumbing System
Opening the exterior water heater panel:
Turn the locking knob, and open the exterior water heater
panel to the
first
open position (
A
).To open the panel to the
second
(or service position), the door must first be open as
shown in the first photo. Then lift the door so it comes out of
the slots along the bottom of the door (
B
).
Lower the door so it lays flat against the RV hanging by the
straps ( C ).
To close it, insert the tabs back into the slots at the bottom
of the door and close the panel, and rotate the locking knob.
Make sure the straps are not pinched between the door and the
cover plate.
Filling the water heater:
Close the bypass lines (if so equipped).
Turn on the fresh water supply or switch on the water pump.
Fill the plumbing system. Open all faucets, showers, toilet to
bleed air from the lines.
When water begins to flow the system is vented. Close all
fixtures.
Turn on the water heater:
Make sure LP gas supply is turned on.
Turn on the 12V power in the RV.
Open the water heater access door (see explanation
above).
Turn the power switch on by selecting either ECO or
COMFORT position. The green LED will light at the
top of the switch.
If the RED LED below the switch lights or flashes, it indicates an error condition.
Refer to the appliance owner manual for error codes.
NOTE: The panel will only open enough to
access the power switch on the inside. This is
intentional. DO NOT TRY TO FORCE
THE PANEL OPEN FURTHER.
NOTE: The Aqua Go BASIC water heater will not have ECO/COM -
FORT settings. It only has a basic power switch. It should
NEVER
be operated in freezing conditions. If the vehicle is standing and
ambient temperatures are below -4°F (-20°C) the appliance must not
be operated and must be winterized.
Table of Contents Maintenance Record