Jayco MELBOURNE, Руководство пользователя

Страница: 49 / 106

To assist the siphoning process, put the
container on a suface approximately two
feet above ground level.
7. Turn the water pump ON.
If the water pump fails to self-prime,
temporarily open the low point drains
(close the low point drains as soon as the
water pump primes [RV antifreeze will
begin draining out] and before continuing
to the next step).
8. Open the hot water line on all the faucets
(kitchen, lavatory, shower and outside
shower) until RV antifreeze begins to flow
continuously.
9. Close the faucet hot water lines and repeat
with the cold water lines on all the faucets.
Do not forget to run RV antifreeze through
the toilet.
When you are done adding RV antifreeze
10. Remove the garden hose from the
container of RV antifreeze.
11. To prevent staining, wipe the RV
antifreeze out of the sinks, shower (or tub)
and toilet using a soft, dry cloth.
To reduce the chance of contamination,
prevent the garden hose from coming into
contact with the ground. If needed, contact
your RV dealer for assistance.
S
ANITIZATION
Potable water systems require periodic
maintenance to deliver a consistent flow of
fresh water. For your personal safety, the
plumbing system should be sanitized when
your RV is new, at the beginning and end of
each season and when the water system
becomes contaminated (or approximately
every three months of use).
How to sanitize
1. Level the RV and drain the fresh water
system.
2. Prepare a chlorine solution using 1/4 cup
of household bleach (sodium hypochlorite
solution) to one gallon (3.785 liters) of
water in a container. Prepare one gallon of
solution for every 15 gallons of tank
capacity. This will result in a residual
chlorine concentration of 50 ppm in the
water system.
If a 100-ppm concentration is required as
discussed in step 13, use ½ cup of
household bleach with one gallon of water
to prepare the chlorine solution. One
gallon of the solution should be used for
each 15 gallons of tank capacity.
3. Attach the intake hose to the city fill
connection located on the utility center
panel. Place the free end of the intake
hose in the bucket of chlorine solution.
To assist the siphoning process, put the
container on a surface approximately two
feet above ground level.
4. Turn the water heater valves to the
“BYPASS” position.
5. Move the valves to the “Sanitize Tank”
position. The low point drains must be
closed for the chlorine solution to siphon
through the lines.
6. Turn the water pump ON.
If the water pump fails to self-prime,
temporarily open the low point drains
(close the low point drains as soon as the
water pump primes [RV antifreeze will
begin draining out] and before continuing
to the next step).
7. After the recommended amount of solution
is in the tank, turn OFF the water pump.
45
SECTION 5
PLUMBING SYSTEM
WARNING
Chlorine is poisonous. Always recap the
household bleach bottle and clean utensils
and containers after use.
WARNING
Failure to sanitize the potable water system
could result in death or serious illness.