34
Section 4: Vehicle Operation
cause clearance problems around some tunnels, canopies and hanging signs.
When turning, the tires do not follow the path of your tow vehicle tires. The RV will make
a tighter turn than the tow vehicle. Compensate for this action by carefully pulling the tow
vehicle out into the intersection further than you would normally so that the RV clears the
curb. When making a turn, check the road clearance and be aware of others. Swerves and
sharp turns, especially at high speeds, could result in loss of control of the RV.
If your camping destination does not have pull through sites, pick a level site and back in
carefully. Check to ensure there are no obstacles in your path and that you have plenty of
vehicle clearance.
After the RV is in the desired location, set the tow vehicle parking brake. Block all RV
wheels securely with wheel chocks to prevent it from rolling.
RV Brake System
Even though your RV is equipped with brakes designed for GVWR, proceed with caution
until you become accustomed to your RV’s stopping distance.
Driving through water deep enough to wet the brakes may affect stopping distance or cause
the vehicle to pull to one side. Check the RV’s brake operation in a safe area to be sure they
have not been affected.
Never operate any vehicle if a difference in braking efficiency is
noticeable.
Electric Brakes
The electric brakes are designed to work with the tow vehicle brakes. To maintain
proper braking performance, both the RV and tow vehicle brakes must be used to-
gether. Separate use of the braking systems will cause accelerated wear and damage.
When your RV is new, it is impossible to adjust the brake shoes precisely. It takes approxi-
mately 1,000 miles and/or 50 medium to heavy stops to “burnish” fit or “seat” the shoes to
the brake drum. After the initial break-in period your brake shoes must be adjusted accu-
rately for best performance and increased durability.
Braking system components include:
Tow vehicle battery
Tow vehicle brake controller
Wire harness/connector plug
Trailer battery
Breakaway switch and alarms
The tow vehicle battery is the primary source of power for your RV’s electric brake opera-
tion. To ensure available power when needed, keep your tow vehicle battery and charging
system working properly.
Brake Controller (customer supplied)
The brake controller should be installed in the tow vehicle to work in conjunction with the
RV electric brakes.
Consult with your dealer or the brake controller OEM to decide what is right for your towing
combination.
Failure to maintain the brakes in proper working condition as specified in the
operator’s manual supplied by the axle OEM will cause property damage,
personal injury and possibly death. Consult with your dealer for assistance.
Table of Contents
Содержание JAY FLIGHT 2023
