Jayco Heritage, Руководство пользователя

Страница: 31 / 87

22
CANOPY INSTALLATION AND SETUP
Before installing canopy, note these two observations for correct installation.
1. Three or more brass grommets are installed in the vinyl bag for breathing purposes.
Grommets must be on the lower side.
2. Zipper tab in closed position will be in
the rear of the camper.
Install
1. Slide the hard round plastic extrusion
into rail mounted to roof.
2. Position the front end of the canopy even
with the rail at the front end.
3. Drill 1/8" hole, 2" from front of unit,
through plastic rail and plastic extrusion.
4. Insert one screw (8x1/2" P/H, pan-head,
Part #0051594) through the hole to hold
the canopy in position.
Setup – Folding Camping Trailer Self Storing Canopy
Your canopy has been designed and built with quality material to give you years of
trouble free service with low maintenance.
Read these instructions fully before beginning setup. Become familiar with each pole, its
description and where it belongs. Refer to Fig. 1
One person can do the setup, but two people will make it easier.
1. Open zipper and unroll canopy fabric.
2. Insert the two end divider bars “C” (with gray caps) and center spacer bar “D” (7/8"
tube) into front pocket of the canopy. These bars may be left in the canopy during
travel or storage, but should be removed during winter storage to avoid corrosion.
3. Assemble the two parts of a tension rafter, Pole “A.” Insert the peg through the
“eye” of the twist pole “B” and then through the hole in the middle of the center
spacer bar “D.” Compress tension rafter and place in the center of the roof side
board, as pictured. The rubber tip from the tension rafter will rest against the roof
metal or the canopy bag.
4. If no screen room is being installed, repeat step #3 on the front and rear tension
rafter, inserting the end of the tension rafter through twist poles “B” and the end
divider bars “C.” Position tension rafter as in step #3.
5. After all the poles are installed:
a) Adjust the canopy to fit properly.
b) Adjust the height of the canopy with the twist lock poles.
c) Install the three stakes to anchor the canopy in case of strong winds.