Jayco Eagle FW 2021, Руководство пользователя

Страница: 141 / 211

Section 8: Plumbing System
139
3. Connect other end of the hose to the pressurized fresh water source.
4. Turn ON the pressurized water source.
5.
Water should now be available to all fixtures in the RV.
To disconnect:
Turn off water at the pressurized source first, disconnect hose from the water
source, (to release pressure off the system) then disconnect the hose at the city water con
-
nection on utility center last.
“SANITIZE” (or Siphon Fill) the Fresh Water Tank via Pump
“WINTERIZE” (plumbing lines and fixtures via pump)
Sanitizing The Plumbing System: (with a tank (storage) water heater)
When to sanitize:

When your RV is new.

At the beginning and end of each season.

When the water system becomes contaminated or every three months of use.
How to Sanitize
1. Turn water heater power OFF (both electric and LP gas on standard storage water
heater). Set the colored valves to
SANITIZE/WINTERIZE
setting:

Green valve pointing left.

Blue valve pointing down.

Set the red water heater bypass lever to
BYPASS
. Red lever
will be pointing up.
2. Level the recreation vehicle and drain the fresh water system (see
Draining the Fresh Water System ). Do not drain the water heater
or remove the water heater drain plug.
3. Close the low point drain valves and the fresh water tank drain valve.
NOTE: Refer to the
Sanitizing Plumbing System
section for complete
instructions on how to sanitize the water lines.
NOTE: Refer to the
Winterizing Plumbing System
section for complete
instructions on how to winterize the water lines and fixtures.
NOTE: Refer to the valve operation diagram on
the utility center for positions of the colored valves.
The water heater bypass valve is located in the utility
center bay.