![background image](http://html1.mh-extra.com/html/jayco/alante-2023/alante-2023_owners-manual_3506453090.webp)
84
Section 8: Plumbing System
NOT OVERFILL
. Tank level can be viewed on the monitor panel inside the RV.
6.
Disconnect water source from the spigot/faucet first, then disconnect from the city wa
-
ter fill inlet on the utility center.
DRY CAMPING (pump supplies water from the fresh water tank)
1.
Make sure the fresh water tank has an adequate supply of water.
2.
Set the color coded valves to the DRY CAMPING setting:
White handle pointing down
Blue handle pointing left
Green handle pointing up
Red handle pointing up
3.
Turn the pump switch ON.
4.
Water should be available to all fixtures.
5.
Turn pump OFF when water is not being used.
NOTE: To fill the fresh water tank without a pressurized water source, re-
fer to SANITIZE (Siphon Fill) section, and use a container holding fresh
potable water and a hose. Water will be drawn into the tank by the pump.
There is no gravity fill inlet on the recreation vehicle. DO NOT OVERFILL
THE TANK!
CITY WATER (pressurized fresh water source)
1.
Connect the fresh water hose to the city water inlet.
2.
Set the color coded valves to the CITY WATER setting:
White handle pointing down
Blue handle pointing left
Green handle pointing left
Red handle pointing right
3.
Connect other end of the hose to the pressurized fresh water
source.
4.
Turn ON the pressurized water source.
5.
Water should now be available to all fixtures.
6.
Turn off water at the pressurized source first, disconnect hose from the water source,
then disconnect the hose at the city water connection on utility center.
Sanitizing The Plumbing System
When to sanitize:
When your RV is new.
At the beginning and end of each season.
Every three months of use.
When the water system becomes contaminated.
Preparing to sanitize
Prepare a chlorine solution using 1/4 cup of household bleach (sodium hypochlorite solu-
tion) to one gallon (3.785 liters) of water in a container. Prepare one gallon of solution for
every 15 gallons of tank capacity. This will result in a residual chlorine concentration of 50
ppm in the water system and should remain in system for at least 4 hours.
If a 100 ppm concentration is prepared, use ½ cup of household bleach with one gallon of
water. One gallon of the solution should be used for each 15 gallons of tank capacity. Allow
to remain in system for at least 1 hour.
NOTE: Fresh water tank sizes vary by model. Contact your dealer or Cus-
tomer Service for your specific tank size.
Table of Contents
Maintenance Record
Содержание ALANTE 2023
