Jayco ALANTE 2023, Руководство пользователя

Страница: 62 / 139

56
Section 6: Electrical System
with a ground monitor before connecting your power cord to it. If the ground monitor indi-
cates ‘reverse polarity’ or an ‘open ground’ DO NOT connect the power cord.
To help prevent power surges from damaging the connected loads, please follow these in-
structions when hooking up to the external power source:
1.
Turn off the load center main 120-volt circuit breaker.
2. Carefully extend the entire length of the power cord (approximately 25’-35’) from the
electric cable hatch to the external power source.
3. Plug the power cord into the receptacle. Be sure all the power cord prongs are properly
plugged into the receptacle.
4. Return to your RV and turn on the load center main circuit breaker.
The shore power cord should be unplugged when the recreation vehicle is left unat-
tended.
When you are ready to leave, reverse the power cord connection process. Use care to prevent
damaging the power cord electrical connection pins when connecting or disconnecting the
shore power cord. Grasp the plug to remove the power cord from the outlet; do not unplug
it by pulling on the cord.
Maintenance
Inspect the power cord for cuts, cracks and worn insulation. Have the power cord replaced
immediately if these symptoms are noticed.
Inverter
A factory installed inverter converts 12-volts
DC to useable 120-volts AC and supplies AC
power to the appliance plugged into it. It is im-
portant that you familiarize yourself with the
inverter function and operation. The inverter
should be “off” when not in use.
™
NOTE: The inverter is not intended for
use, nor should be used, with any medi-
cal device(s). The inverter may, however,
be used with some CPAP machines, de-
pending on the CPAP model. Consult
your CPAP machine’s instruction manu-
al before use to ensure proper operation.
The inverter has a remote display panel which provide many features:
Feature Description
1
Display panel
displays status information on the screen. It is comprised of
a display screen, LEDs, select and power buttons.
2
Multi-function LCD screen
shows status information and error codes.
3 Status LEDs
indicate the mode of operation.
4
Three
function buttons
change status information displayed on the
screen. Also, changes inverter settings.
5 Power button
is pressed for turning on the unit. The inverter turns on for
the loads automatically.
Table of Contents Maintenance Record