![background image](http://html1.mh-extra.com/html/jayco/alante-2023/alante-2023_owners-manual_3506453105.webp)
99
Section 8: Plumbing System
9.
Connect the blowout plug to the Black Tank Flush inlet at the utility center panel.
10.
Colored valves have no effect on the black tank flush inlet.
11. Connect the air hose to the blowout plug. Set the compressor to
30 PSI maximum
.
12. Open the black tank drain gate valve, macerator bypass valve is open also.
13.
Blow air into the flush inlet for 30 to 60 seconds.
14. Disconnect the air hose, compressor and blowout plug.
15. Close the black tank drain gate valve and close the macerator by-
pass valve.
Draining the Spray Port
With fixtures and drain valves open in the RV to drain the water lines,
connect the blue-coiled hose to the brass quick connect fitting at the
Spray Port.
1.
Remove the spray nozzle from the other end of the hose.
2.
Hold the open end of the hose near the ground and any water in the line should drain
out.
3.
Disconnect the hose from the fitting, and store in the RV.
4.
Close the port cover.
Winterizing the Spray Port with Antifreeze (if so equipped)
1.
As you are putting antifreeze into the water lines, attach the hose to the Spray Port.
2.
Have a container close by to capture antifreeze.
3.
Pull the trigger on the spray nozzle until antifreeze comes out (into the container).
4.
Release the nozzle and disconnect the hose from the port.
5.
Rinse out the hose before storing it.
Tank Heaters
Your recreation vehicle may be equipped with heaters for the fresh, gray, black water tanks.
These heaters will prevent water in the tanks and lines from freezing down to -11°F (-24°C)
(contingent on recreation vehicle setup).
The larger tank heaters are 120VAC and attach directly to the tanks. The thermostat con-
trolled tank heaters will cycle on at 44°F (7°C) and off at 64°F (18°C). All of the heaters are
controlled by a single ON/OFF switch that is typically located on the command center panel
or in the bathroom. The switch lights up red when ON and controls the heater circuit.
The tank heater switch should be turned ON:
When liquid is present in the holding tanks and the outside temperature approach-
es and maintains freezing conditions 35°F (2°C) or colder.
In order for the 120VAC tank heaters to be in operation, the recreation
vehicle
MUST
be hooked up to shore power or under generator power.
If the recreation vehicle is not operating on shore power or generator
power,
the heaters will not operate.
This can result in the tanks freez-
ing.
The red light on the command center tank switch does not necessarily
indicate that
ALL
heaters are operating; it is only a warning that the
heater circuit is ON.
Table of Contents
Maintenance Record
Содержание ALANTE 2023
