Jayco Alante 2018, Руководство пользователя

Страница: 122 / 169

112
Section 8: Plumbing System
How to sanitize (
no utility center
)
1. Set the bypass valves to bypass the water heater: valves A&B closed and valve C open
(refer to
Water Heater Bypass Valves section).
2. Put the sanitizer solution in the fresh water tank: Insert one end of a hose (or funnel) in
the gravity fill inlet, insert the other end into a container holding the chlorine solution.
Do not use your non-toxic drinking water hose. Pour the chlorine solution into the
gravity fill.
3. Remove the hose (or funnel) and container used to pour the chlorine solution, and
continue filling the fresh water tank with clean (potable) water until tank is full: Pour
fresh water into the gravity fill inlet until tank is completely full.
After the recommended amount of sanitizing solution is in the tank, the water tank is
full, and water filter has been removed, turn the pump ON which sends sanitizer into
the water lines.
4.
Open all hot water faucets one by one until water begins to flow continuously and a
chlorine smell is noticeable. Include outside shower faucets (if so equipped).
5. Close the hot water faucets and repeat opening all cold water faucets one by one until
you smell chlorine. Include outside shower faucets (if so equipped) and toilet.
6. Turn OFF the water pump.
7. Let the solution remain in the tank & lines for at least four hours when disinfecting with
50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM chlorine
concentration should be permitted to sit in the system for at least one hour.
8. After the required period, drain the chlorine solution from the fresh water system (see
Draining the Fresh Water System ). Since the water heater was bypassed there should
be no sanitizer in the (storage) tank water heater.
Rinse the system with fresh water:
9. Fill the fresh water tank full of clean (potable) water. Fill fresh water tank from an
external container. Pour fresh water into the inlet using a hose (or funnel).
10. Power to water heater should be OFF. (both switches: electric & LP gas) When the
fresh water tank is full: Turn the pump ON to send water through the lines.
11. Run water through all faucets (hot & cold, including outside shower) until chlorine
smell is gone. Turn faucets and outside shower off, turn pump OFF.
12. Then, drain the fresh water system again. (see Draining the Fresh Water System ).
13.
Water heater bypass valves (if so equipped)
close bypass valve C, open valves A and
B on water heater, replace water heater drain plug.
14.
Refill the fresh water tank with fresh water again and when water heater is full of
water, turn the water heater power ON. Refer back to Step 14 above for instructions on
refilling the fresh water tank.
NOTE: The full system canister must have the filter removed
Table of Contents Maintenance Record