Jayco 2016 Melbourne, Руководство пользователя

Страница: 88 / 169

78
e
lectrical
S
yStem
r
eplAcinG
l
iGht
b
ulbs
Before replacing a bulb, be sure the light is off. Do not touch the glass part of the new bulb
with your bare fingers. The skin oil left on the glass will evaporate when the bulb gets hot,
the vapor will condense on the reflector and it will dim the surface.
Replacement light bulbs must be of the type, voltage and wattage listed on the lamp fixture.
Use of incorrectly sized bulbs can overload lam circuits and may create a fire hazard by
overheating the fixture.
c
oMMAnd
c
enter
The command center is typically located just inside the entrance door or in the living area of
the recreation vehicle. It contains switches and controls for electrical functions for the RV.
Depending on your model, the command center may be a panel complete with switches, or it
can be a group of switch pods mounted to a recessed panel inside a cabinet. Some models
may have the switches and controls mounted directly to the wall in the living area or vicinity
of the entrance door. In some cases, the systems monitor (which indicates tank levels and
battery charge) may also be included on this panel (refer to the
Monitor Panel
section).
Command Center Panel:
Items found on this panel typically include (may vary by model):
Fuel gauge and hour meter with switches for fuel pump and fuel levels
Lighted red pump switch, lighted red water heater switches (electric & LP gas)
Generator start / stop switch
Tank heater switches
Light switches for porch lights, exterior security lights, interior lights, awning
Mounted to wall
Command Center Panel W/Switch Modules
Command Center Panel
NOTE: Command center configurations and components may vary
from model to model. Not all components listed may be available in
your model.