OPD Overfill Protection
Your LP gas container(s) are equipped with Type 1 ACME LP Gas Connections. No tools
are required to tighten or loosen the connections. They are designed so gas will not flow
from the container unless the correct connection is made.
Make sure you read, understand and follow the information supplied with your unit that is
relevant to the LP gas container connections for your safety and convenience of use of the
OPD overfill protection.
The position of the LP gas container(s) and the hoses are critical to proper operation and
gas flow. Follow these instructions to make sure your LP gas container(s) are connected
properly.
DUAL CYLINDER ASSEMBLY WITH BOTTLE RACK ON A-FRAME OR FRONT TRUNK
The containers must be positioned in the tray with the valves pointing away from the
trailer. The wing nut is placed on the threaded rod to hold the cross bar down and orient the
containers. The regulator bracket is held in position by the threaded rod and centers the
regulator between the two cylinders which are secured at the base on the tray.
1. Connect the 3/8" low-pressure hose to the outlet of the
two-stage regulator.
2. Place the cylinders on the bracket provided on the
A-frame and secure them so the outlet of the cylinder
valves point outward from the front of the sport utility
trailer.
3. Using the threaded center rod, position the regulator
bracket. This centers the regulator between the two
cylinders as they are secured to the base tray.
4. Attach the inverted flare x 11" Type-1 pigtail hose to
the regulator inlet and the right hand swivel nut to the
cylinder valve.
I
WARNING: The pigtail hose must be installed to avoid tension or
pulling stress at either end of the hose.
I
WARNING: Keep the pigtail hose away from sharp edges of the
cylinder collar, rigid corners, walls, doors or other compartment
structures including the cover.
.
NOTE: The regulator is typically installed with the inlet fittings at the same level as
the cylinder outlet valves. Due to bracket design, wing nut clearance or cover
restrictions, the regulator fittings may not be in perfect alignment with the cylinder
valves. A variance of two (2) inches (5 cm) above or below the line will permit the
hoses to be properly installed.
Talon Sport Utility Trailer and Fifth-Wheel Sport Utility Trailer
73
Utilities & Systems
Fig. 58
Содержание 2005 Talon ZX
