2.4 Switch setting
Figure 2.11 Dial-up switches description
1: SW1 address dial-up switch 2: SW2 baud rate and parity switch
The two dialing switches SW1 and SW2 on device base board are used to set device address, baud rate,
communication protocol and other parameters (as shown in the Figure 2.11, in which switch ON stands for 1).
In SW1 and SW2, 1 is the lowest position and 8 is the highest position. Please refer to the following list for
specific setting:
Note: This speed dome Self-adaptive Pelco-P, Pelco-D and HIK Code protocols.
2.4.1 Device address setting
SW1 is used to set device address as follow:
Device address Dialing setting schematics 1
2
3
4
5
6
7
8
0
OFF OFF OFF OFF OFF OFF OFF OFF
1
ON OFF OFF OFF OFF OFF OFF OFF
255
ON ON ON ON ON ON ON ON
More examples for address codes dialing mode:
Code dialing
SW1 switch setting
address 1 2 3 4 5 6 7 8
0 OFF
OFF OFF OFF OFF OFF OFF OFF
1 ON
OFF OFF OFF OFF OFF OFF OFF
2 OFF
ON
OFF OFF OFF OFF OFF OFF
3 ON
ON
OFF OFF OFF OFF OFF OFF
4 OFF
OFF
ON
OFF OFF OFF OFF OFF
5 ON
OFF
ON
OFF OFF OFF OFF OFF
6 OFF
ON
ON
OFF OFF OFF OFF OFF
7 ON
ON
ON
OFF OFF OFF OFF OFF
9
