Operator’s Manual
DETACHING LOADER
Attaching and detaching of the loader should be performed on even and solid ground.
Bucket does not have to be on the loader – loader is stable even without the bucket.
If a bucket is attached, it must be level – in horizontal position (see picture).
1.
Stop engine and lower loader to ground (move joystick forward). To detach the loader easily, the
bucket must be seated flat on the ground with its bottom side.
2.
Engage the hand brake. Release and fold down stands (1).
Note:
Adjust the height of the stands so they will be just touching the ground
3.
Move joystick control at least three times in all directions to remove any pressure from the system.
4.
Disconnect four hoses with quick couplers from the loader valve. Plug disconnected couplers and
hoses with rubber plugs, prevent hydraulic system contamination.
5.
Move levers up after releasing latch on each lever.
Push each lever all the way back to the stop. This will release the loader from its brackets.
6.
Drive the tractor slowly away from the loader.
T50SS/T50HLSS
5
