JAWA 250 TRAVEL, Руководство по эксплуатации

Страница: 8 / 23

8
Direction indicators
12V / 10W lamps.
Front lamp
It is fitted with a halogen bulb H4 12V 60 / 55W, and parking light bulb 12V 4W.
Taillight
Fitted with 1-piece bulb 12V 5W.
Stoplight
Fitted with 12V 10W bulb.
Left switch (Fig. 9)
1. Headlight switch – high/low beam
2. Indicators, left/right
3. Headlight flasher
4. Warning horn
5. choke lever
Right switch (see Figure 7)
With two controls:
1. on/off headlight switch
2. starter switch
Instrument Panel
Instrument panel (see Figure 2) is equipped with (on the left) a tachometer, then warning light devices
and, on the right an electronic RPM meter.
On the control panel are the following lights:
1st upper left (green):
LED function indicator lights
2nd bottom left (green): Neutral light
3rd top right (blue): Headlights
4th bottom right (red): vacant
Lighting equipment (speedometer and tachometer)
Baseless lamp is fitted with a 12V / 3W. Warning light panel uses baseless lamps 12V/2W.
4th RUNNING-IN MOTORCYCLE
A new motorcycle needs at least 1,500 – 2,000 km before its power can be fully utilized.
Conscientious running-in of machinery extends the life of the machine and also its maximum
performance. The motorcycle must be run in a flexible manner (don’t unnecessarily overload nor over-
rev the engine) and take care especially about these guidelines:
Do not over-rev the engine, especially in first gear at idle or when not on the move. Maximum speed
in these modes can not exceed 5,000-5,500 RPM in each gear.
The engine speed while driving should be raised to 6000 RPM and maintained about there, and
thus it is necessary to adapt one’s driving style (don’t slog or over-rev the engine).
The clutch may be used in jump-starting and while moving the motorcycle in reverse. Avoid slipping
the clutch to prevent damage to the plates.
Occasionally check and tighten all fasteners, especially the engine mounting and rear swinging arm.
Changing the oil in the engine will be necessary after the first 500 km (see chapter on oil changes).
Tighten all connections on the motorcycle and check that the battery contacts are clean.