3
Pairing the Radio
Pairing the Radio
Your radio (HPTxxxBT) and the
TRIUMPH-2
receiver come
from the factory already paired and ready to communicate
with each other out of the box. Once powered, both the
radio and receiver will show their blue LEDs lit indicating
their linked communications. Usually this only takes a few
seconds.
When you purchase a radio from Javad GNSS separately
from the purchase of the receiver,
is available to
establish their pairing. It can also be used in establishing a
pairing with multiple radios in the series which include: the
HPT901BT*, HPT401BT, HPT404BT and the HPT435BT.
* Note: The
TRIUMPH-2
paired with the HPT901BT works as a UHF
base for the
TRIUMPH-LS
when the FH915 radio has been installed
at the factory on the
TRIUMPH-LS
.
Procedure
Step 1. Connect the
TRIUMPH-2
to your PC using the USB ca-
ble: USB Cable, A / micro B, (3.3 ft / 1.0 m) [14-578156-01].
Power the
TRIUMPH-2
on.
Step 2. Connect the HPTxxxBT to your PC via a serial port
or through a USB to serial adapter. Be sure to connect the
antenna before powering the radio on. Depending on your
radio, the following cable choices will then apply:
