*ASON)NTERNATIONAL)NCs
501.771.4477
Page 8 of 12
Customer Service : 800.255.5766
Copyright © 2013 Jason International.
OPERATING INSTRUCTION, FEATURES, AND CONTROLS (cont.)
The blowers Air On/Off button control box is built to plug into
the dedicated GFCI electrical circuit. A 36” power cord with
a plug end is prewired to the blower, which must be plugged
into the control box. A built-in timer shuts the blower off
20-minutes after being activated.
Automatic Purge Cycle
Fifteen minutes after the blower is stopped, the blower will
automatically start for two (2) minutes to purge and dry the
air channel system.
WHIRLPOOL OPERATION
All Jason Integrity
®
Whirlpool baths are pre-plumbed at
the factory with standard equipment. Standard equipment
includes five (5) or more directional hydrotherapy jets, and
an air actuated On/Off switch.
CAUTION: Keep hair, towels, and clothing away from the
suction fitting whenever the equipment is On. Never oper-
ate the equipment with the suction cover off, doing so voids
the manufacturer’s warranty--it is a safety cover designed to
eliminate the potential of hair and body entrapment.
Filling and Draining
Close the drain and fill the bath with water at least two (2)
inches (50mm) above the jets. The inlet temperature should
not exceed 40°C (104°F).
CAUTION: NEVER RUN THE WHIRLPOOL PUMP WITH-
OUT ENOUGH WATER IN THE BATH TO COVER THE
JETS.
Before starting the pump, direct the jet nozzles downward to
prevent the possibility of water splashing from the bath. When
bath is in use, turn the unit Off before draining the water. The
bath unit and its plumbing are designed to drain after each
use whether used as a hydrotherapy bath, soaking bath, or
just taking a shower.
Air ON/OFF Button
The Air On/Off button provides a safe
and convenient method for controlling
the Whirlpool bath. The Air On/Off
button is factory mounted onto the
bath prior to shipment. See Figure
3a for the location of the Air On/Off
button (air actuator) on the Whirlpool
bath. Fill the bath to at least two (2)
inches above the highest jet and
press the Air On/Off button to start
the whirlpool pump. Press the Air On/
Off button again to stop the whirlpool pump.
Whirlpool Jets
Five or more strategically placed whirlpool jets are provided
for complete enjoyment of the bath. The jets are specially
designed for maximum whirlpool action with direction and flow
control. Changing the direction of the jets will concentrate the
massaging jet stream to the area of preference and turning
the flange of the jet will adjust the amount of flow.
Whirlpool Pump
The pump provided on Integrity
®
Whirlpool baths is factory
tested when assembled onto the bath. The pump is designed
to incorporate high quality, long-life seals which provide su-
perior service. However, should the pump need service, use
the suction and discharge unions provided for easy removal.
NOTE:
If the unit fails to operate, check the breaker
panel to insure that the circuit breaker is on. Check the
GFCI by testing and resetting it. If the unit still fails to
operate, refer to the Trouble Shooting Guide section of
this manual. If the unit still fails to operate and is out of
warranty, contact an authorized service technician for
repair. If the unit is within the warranty period, contact
JASON Technical Services at 800-255-5766. DO NOT
ATTEMPT TO RESOLVE THE PROBLEM.
