Remove the ba�ery
Ensure the ba�ery is off. Align the key port with the
appropriate off posi�on by inser�ng the key into the
keyport and rota�ng to align the key with the off icons.
For your convenience, the jasion ba�ery can be removed.
When the ba�ery is removed, be careful not to drop or damage the ba�ery when loose from the bike. Avoid
damaging the exposed connector terminals and keep them clear of debris.
When installing the ba�ery, ensure the ba�ery is turned off before sliding the ba�ery into the frame mount
receptacle. Do not force the ba�ery onto the receptacle; slowly align and push the ba�ery down into the
receptacle. Ensure the ba�ery has been properly secured to the bike before each use by carefully pulling
upwards on the ba�ery with both hands to test the security of the a�achment of the ba�ery to the mount.
Carefully slide the ba�ery upwards and li� it off the
frame. Note: the ba�ery weighs around 5.7 lbs and
should be handled with care.
Do not use the thro�le while dismounted. Avoid accidental applica�on of the thro�le
while dismounted; any�me you are moving the bike while dismounted, ensure the
bike is powered off to prevent accidental applica�on of the thro�le.
Start-up procedure
13
14
5.Begin riding carefully. With the proper safety gear and rider knowledge, you may now operate your
bike. On a flat surface, in a low gear (1 or 2), most riders should be able to begin pedaling the bike with
pedal assist level 0 or 1. You may also use the thro�le to accelerate and maintain your desired speed.
6.The thro�le is used by slowly and carefully rota�ng the thro�le backward toward the rider. Do not
use the thro�le unless you are on the bike.
A�er the bike has been properly assembled according to the assembly video, all components are
secured correctly, a cer�fied, reputable mechanic has checked the assembly, and you have read
this en�re manual, turn on the bike and select a pedal assist level following the steps below:
1.Familiarize yourself with the ba�ery power posi�ons. Turn on the ba�ery first and cover the rubber
case, ready for a ride.
2. Turn on the bike. With the ba�ery locked in place. Locate the LCD display controls (near the le�
handlebar grip). Hold down for approximately 1 seconds un�l power is delivered to the LCD
display and turn on.
3.Turn on the front light or taillight if needed or desired. Long press + bu�on (1 second), the
brightness of the backlight of LCD Display will decrease. Long press + bu�on again (1 second),
the backlight of LCD Display returns to it's original brightness.
4. Select the desired level of pedal assistance (PAS) between level 0~5 using the + and - on
the LCD display. Level 1 corresponds to the lowest level of pedal assistance, and level 5
corresponds to the highest level of pedal assistance. Level 0 indicates pedal assistance is inac�ve.
Start in PAS level 0 or 1 and adjust from there.
Содержание EB5
Страница 20: ......
