Jasic TIG200, Руководство пользователя

Страница: 19 / 59

Page 19
5.4. TIG welding torch and earth cable connection
1) Ensure that the power switch is turned off.
2) Insert the cable plug with earth clamp into the positive socket on the front panel of the
welder and tighten it clockwise.
3) Insert the cable plug of the welding torch into the corresponding negative socket on the
front panel of the welder and tighten it clockwise.
Note! The positive and negative polarities should not be reversed as this will prevent
normal welding operation.
4) Insert the gas connector of the welding torch into the gas vent on the front panel.
5) Connect the gas hose of the argon cylinder to the inlet nozzle on the rear panel of the
machine.
Figure 5-5 Connection of welding torch, earth cable and gas cylinder
NOTE! If you want to use long secondary cables (TIG torch cable and earth cable), you
must ensure that the cross-sectional area of the cable is increased appropriately in
order to reduce the voltage drop due to the cable length.