A WILKINSON STAR LIMITED PRODUCT 12-16 ISSUE 1
TIG Welding
Insert the cable plug with the work clamp into the “+” socket on the front panel of the welding machine,
and tighten it clockwise. Insert the cables plug of the TIG torch into the “-” socket on the front panel of
the machine and tighten clockwise.
Connect the gas hose to the regulator / flowmeter located on the shield gas cylinder and connect the
other end to the machine.
OPERATION
Before starting any welding activity ensure that you have suitable eye protection and protective
clothing. Also take the necessary steps to protect any persons within the area.
MMA
After connecting the welding leads as detailed you will need to switch the power switch on the back
panel to “ON” . Select MMA by switching to the MMA welding mode. There is voltage output at both
output terminals. Set the amperage on the machine suitable for the electrode being used. Please see
below a guide to amperages required. Ensure you check that you have the electrode polarity correct.
Electrode Diameter (mm)
Recommended Welding Current (A)
1.0
20~60
1.6
44~84
2.0
60~100
2.5
80~120
3.2
108~148
4.0
140~180
