21
NAVIGATING THE ‘LCD’ CONTROL PANEL
Selection and adjustment of welding parameters
When selecting the required parameters, the operator may first need to press the central encoder button
to highlight the welding current setting, once highlighted as shown below this then allows the operator to
rotate the central encoder to then select ‘Parameter Settings’ (P) and then on pressing encoder button
you will then enter the "Parameter Settings" screen page and so on.
As an example of the procedure needed to set torch trigger to 4T mode, please see the following steps:
If the user wants to adjust the operating mode in Synergic MIG, rotate the central encoder to select and
enter ‘Parameter Settings’ (P) screen, then rotate the encoder to select highlight and select ‘Operating
Mode’ You will now see your option choices of either 2T and 4T.
The selected operating mode will change from gray to green. If selected, press the master encoder and a
’ √ ’ will appear alongside the chosen option, indicating that the option is valid.
After the above operation, the user can rotate the master encoder to select other parameters or options,
or press "Back" to return to the upper
-
level menu. If no operation or button is performed or pressed
within 3 seconds, the welder will automatically return to the Synergic MIG home page.
