safety messages to operators,
maintenance and cleanup personnel
Model SER- 03
page 3 of 8
JARVIS
6205015:
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457- 4926
UNITED STATES OF AMERICA E- MAIL.
TEL. 860- 347- 7271 FAX. 860- 347- 6978 WWW. j
arvisproducts.com
SAFETY MESSAGES TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
1. Always
wear eye protection in accordance with OSHA’s eye and face protection requirements (29 CFR
1910.133), and when needed, a dust mask.
2. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before changing the blade.
3. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repair or maintenance.
4. Disconnect
the power supply - or have the power supply disconnected - in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
5. Disconnect
the power supply when the tool is not in use.
6. Never
put fingers, hands or other parts of the body on the cutting edge of the blade or in the cutting path.
7. Test
the tool prior to use or daily.
Depress
the trigger and the tool should start.
Release
the trigger
and the tool should stop.
If the tool malfunctions, remove it from service and report or repair it immedi-
ately
.
8. Never
depress the trigger unless you are going to use or test the tool.
9. Never
make any alterations to the tool.
Report or replace any missing or illegible labels.
10. Always
use both hands when starting and operating the tool to avoid the risk of possible “kick back”
or “recoil”.
Continue
holding the tool firmly with both hands until the saw blade comes to a complete
stop.
