18
90˚
Make sure that the wind sensor is mounted horizontally to the earth,
otherwise the measurement result will be influenced!
Mounting types
Mounting on
Wall mounting
Ceiling mounting
Programming the sun/wind sensor
1.
Set the radio receiver or radio motor on which the sensor is to be taught-in to teach-in mode according to the associated
instructions.
Make sure that no other receiver is in „learning mode“.
2.
Press the learn button on the sun / wind sensor within 10 seconds.
Successful teach-in is acknowledged by a short vibration of the motor connected to the radio receiver or the vibration of
the radio motor.
3.
The sun / wind sensor must then be activated with a hand-held transmitter that has already been taught-in
(see page 19).
The motor (the sunshade) can now be controlled automatically via the sun / wind sensor functions.
The TDSW-01 can also be used to control several motors / receivers (sunshade systems) simultaneously.
It is important to note that the wind and sun conditions on the controlled equipment (awnings, blinds) are equivalent.
To teach-in additional motors / receivers, proceed as described.
Set the receiver (radio
motor) to teach-in
mode according to the
associated instruc-
tions.
Press the learn but-
ton on the sun / wind
sensor.
Motor vibrates briefly.
(engine vibrates)
Activating the sun / wind
sensor see page 20.
INSTALLATION INSTRUCTIONS, MONTAGE AND SETTING OF THE SENSOR
