Japan Radio Co. JLR-7900, Инструкция по эксплуатации

Страница: 108 / 184

4-66
Select VERSION (NMEA)
Select a sentence (IEC)
Select BIT RATE
Select an output sentence
Select an output cycle
Sentence list
4.15.4.4 Sharing data
Data can be shared among the display units that are connected through the RS-485 network.
Set the data to be transmitted. Although setting for reception is not necessary, the baud rate must be
standardized among the display units.
For the linkage, set RS-485ID by referencing "4.15.4.1 Setting RS-485ID”.
Setting transmission
1. Refer to "4.15.1 Change to a maintenance mode" and display a maintenance menu.
2. Select “INTERFACE”, “DATA I/O”, and “RS-485” in this order by using .
3. Select the output format to be set by using
.
1) Selecting
NMEA
4. When an output version is selected by using , a sentence list is displayed.
Available versions are “1.5”, “2.1”, “2.3”, and “4.0”.
5. Select an output sentence by using and set an output cycle.
A cycle can be selected within the range from 1 second to 9 seconds and if OFF is selected, the
sentence is not output.
6. Return control to the BIT RATE selection screen and select BIT RATE by using .
Available bit rates are “38400”, “57600”, “76800”, and “115200”. Normally, “115200” is
recommended.
2) Selecting
IEC
In IEC, VERSION is not selected.
4. When “SENTENCE” is selected by using , a sentence list is displayed.
5. Select an output sentence by using and set an output cycle.
A cycle can be selected within the range from 1 second to 9 seconds and when OFF is selected,
the sentence is not output.
6. Return control to the BIT RATE selection screen and select BIT RATE by using .
Available bit rates are “38400”, “57600”, “76800”, and “115200”. Normally, “115200” is
recommended.
Since data is transmitted between display units, some time lag occurs at the switching of
display.
When the bit rate is set to 115,200bps (Max speed), up to 4 sentences can be output.
Supplement
Select an output format
Procedure