Janser COSMO II, Инструкция по эксплуатации

Страница: 5 / 30

Page 4
RULES FOR SAFE OPERATION
14. DO NOT FORCE : Machine will perform best at the rate for which it was designed. Excessive force
only causes operator fatigue, increased wear and reduced control.
15. KEEP HANDS AWAY FROM ALL CUTTING EDGES AND MOVING PARTS.
16. WEAR GLOVES WHEN CHANGING BLADES.
17. DO NOT ABUSE CORD: Never unplug by yanking the cord from the outlet. Pull plug rather than cord
to reduce the risk of damage. Keep the cord away from heat, oil, sharp objects, cutting edges and
moving parts.
18. DO NOT OVERREACH. MAINTAIN CONTROL: Keep proper footing and balance at all times.
Maintain a firm grip.
19. STAY ALERT: Watch what you are doing, and use common sense. Do not use a tool when you are
tired, distracted or under the influence of drugs, alcohol or any medication causing decreased control.
20. STARTING MACHINE: On/off switch must be in off position before connecting to power source.
21. UNPLUG TOOL: When it is not in use, unplug tool before changing accessories or performing
recommended maintenance.
22. MAINTAIN TOOLS CAREFULLY: Keep handles dry, clean and free from oil and grease. Keep
cutting edges sharp and clean. Follow instructions for lubricating and changing accessories.
Periodically inspect tool cords and extension cords for damage. Have damaged parts repaired or
replaced.
23. STORE IDLE TOOLS: When not in use, store your tool in a dry, secured place. Keep out of reach
of children.
24. MAINTAIN LABELS AND NAMEPLATES: These carry important information. If unreadable or
missing, contact National for a free replacement.
25. MACHINE IS HEAVY, DO NOT DROP: Counter weights are heavy. Take caution when removing
or reassembling.
WARNING: Exposure to dust may cause respiratory ailments. Use approved NIOSH or OSHA
respirators, safety glasses or face shields, gloves and protective clothing. Provide adequate ventilation
to eliminate dust, or to maintain dust level below the Threshold Limit Value for nuisance dust as
classified by OSHA.