3
NEVER START PASTEURIZATION BEFORE FILLING WATER INTO THE PASTEURIZER
OTHERWISE HEATING ELEMENTS WILL BE DESTROYED AND INJURIES MAY OCCUR DUE
TO BURNINGS
MANUAL USE
1.
Place the device on the firm, plain and stable surface.
2.
Put tube stainless steel ( picture 1) in the hole.
3.
Put outlet hose ( picture 2) on the cooling connector.
4.
Put the milk container in the pasteurizer and fill it till mark ˝MAX˝ ( picture 3) In case that milk
container is filled with quantity less then mark ˝MAX˝ it is necessary to fix milk container with the two
fixing hooks ( picture 4) on the upper side of the container.
5.
Fill the pasteurizer with water using the already fixed inlet hose until the water is coming out of the
outlet hose.
6.
Plug in the power. - The display turns on and it shows ˝---˝.
Press the heating key. The red light is on. The display shows the present temperature and begins to heat
till setting temperature. Then it turns automatically on keep warm, the yellow light is on. On display is
shown the setting time which starts to countdown. When it comes to ˝0˝ the voice signal pipes 10 times.
Pasteuriser
turns
off
automatically
and
goes
on
standby.
Setting up the temperature: Press the setting key and display shows the temperature. Press the key ˝ ↑ ↓¨
and choose the temperature between 20°C and 99°C. Press again the setting key. The temperature is set
up.
Setting up the time: After setting up the temperature press again the setting key and on display shows
time. Press the key ˝ ↑ ↓ ˝ and choose the time between 0 - 900 minutes. Press again the setting key and
time is set up. If time is ˝0˝ then after heating up the pasteuriser will be in state keep warm.
Pasteuriser turns off by pressing the heating key.
ERRORS:
On display is shown Er2 or Er3 and pasteuriser does not work -
Pull out the plug and call the authorised service - do not repair it yourself!
SAFETY AGAINST OVERHEATING
In case that in secondary coat is not enough water or that temperature of secondary water rises over 100 °C the
security switch switches off all functions on the device.
In this case you have to check which step from manual use was not done properly. The mistake has to be
removed – usually is not enough secondary water in pasteurizer.
The secondary water must always reach till mark ˝MAX˝ written in the pasteuriser. (picture 6)
RESTART:
1.
first wait that pasteurizer cools down
2.
remove milk container
