19
Feed dog height adjustment
Nut
Setscrew A
Setscrew B
Presser foot
0.90 to 1.00 mm
Surface of the needle plate
Feed dog
Hexagonal socket screw 4x6
Setscrew D
(left handed screw)
Threaded hole C
When the presser foot is lowered in the factory setting mode, the highest position of the
feed dog should be 0.90 to 1.00 mm from the surface of the needle plate.
To adjust:
1. Remove the base and thread cutter cover. (Refer to
page 2 and 3)
2. Turn the power switch ON while pressing the start/
stop button and the reverse stitch button to enter the
factory setting mode.
Press the “Feed Dog” key to select the feed dog
adjusting mode.
3. Lower the presser foot.
4. Turn the handwheel toward you to raise the feed dog
to its highest position.
5. Loosen the setscrew A.
6. Loosen the nut. Adjust the feed dog height by turning
the setscrew B.
7. Tighten the nut.
8. Tighten the setscrew A.
Follow the adjustment procedure below.
Feed dog parallel adjustment:
If the feed dog is not parallel to the surface of the needle
plate at its highest position, adjast as follows:
1. For this adjustment, a hexagonal socket screw 4x6
is required. Insert the hexagonal socket screw into
threaded hole C until it stops.
2. Loosen the setscrew D. (Left handed screw)
3. Turn the hexagonal socket screw 4x6 and make sure
that the feed dog is parallel.
4. Tighten the setscrew D.
5. Loosen the hexagonal socket screw and remove it.
6. Attach the thread cutter cover and base.
Setscrew B
Setscrew D
Hexagonal
socket screw
Setscrew A
Nut
Reverse button
Start/stop button
