Jandy RS-P4, Данные установки

Страница: 10 / 36

Page 10
3.1 Power Center Mounting
1. The Power Center should be located at or
near the equipment pad. Locate the Power
Center at least
ve (5) feet or more away
from pool/spa and ve (5) feet off the
ground. All na tion al, state, and local codes
are applicable.
2. Use the mounting brackets and instructions
provided with the Standard Power Center
and/or Sub-Panel Power Center.
3. Sub-Panel Power Centers have special
code requirements. Be sure to follow all
applicable local and state codes to insure
safe installation.
NOTE The Power Center is not to be considered
as suitable for use as Service Equipment.
Therefore, it is required to have the appropriate
means of disconnection, circuit isolation, and/or
branch circuit protection installed
upstream of
the Power Center.
3.2 High Voltage Wiring
3.2.1 System Power
Figure 2. Sub-Panel Power Center
Ú·´¬»® Ы³° λ´¿§ ß«¨ò í λ´¿§
Transformer
Earth Ground
Bla
ck
White
P
ri
m
ar
y
L
o
w
v
o
lt
a
g
e
ra
ce
w
ay
, d
o
n
o
t
ru
n
h
ig
h
v
o
lt
ag
e
in
t
h
is
c
o
m
p
ar
tm
en
t
From Main
Power
Ground
White
White
Black
Black
Ú·´¬»® Ы³° λ´¿§
ß«¨ò í λ´¿§
Ù®±«²¼
Ò
»
«
¨
¿
´
Transformer
Earth Ground
Breaker Panel
To 120 VAC
Breaker
Neutral
Bla
ck
White
Wire nut to
120 VAC power
L
o
w
v
o
lt
a
g
e
ra
ce
w
ay
, d
o
n
o
t
ru
n
h
ig
h
v
o
lt
ag
e
in
t
h
is
c
o
m
p
ar
tm
en
t
P
ri
m
ar
y
Figure 1. Standard Power Center
Section 3. Installation
WARNING
Potentially high voltages in the AquaLink RS
Power Center can create dangerous electrical
hazards, possibly causing death, serious injury
or property damage. Turn off power at the main
circuit of the AquaLink RS Power Center to
disconnect the Power Center from the system.
Depending on the amount of equipment being
controlled, run
½ " or larger conduit from the
power supply panel to the bottom of the Power
Center. If you are using the Sub-Panel Power
Center, wire power to the appropriate breakers.
Pull in ap pro pri ate wire for equipment. Each piece
of equipment requires its own high voltage relay.
Connect 120 volts to the Power Center terminals.
Connect equipment ground(s). See Figures 1 and 2.