Jandy JandyColors JPL1230, Инструкция по установке и эксплуатации

Страница: 11 / 20

Page 11
Section 5. Wiring Options for Controlling Jandy Pool Lights or Jandy Spa
Lights
NOTE The Jandy Pool and Spa Lights will not operate properly with light dimmers. Do not wire the Jandy Lights to
any dimming circuitry .
To the extent allowed by code and capacity of the electrical equipment, multiple To the extent allowed by code and capacity of the electrical equipment, multiple Jandy Pool and Spa Jandy Pool and Spa
Lights Lights may be controlled with a single switch so their colors will may be controlled with a single switch so their colors will always always be synchronized. be synchronized.
Separate switches may be used to control the on/off and color functions of each Separate switches may be used to control the on/off and color functions of each Jandy Pool or Spa Light Jandy Pool or Spa Light . .
It is recommended that these switches be located next to each other to facilitate simple color synchronization It is recommended that these switches be located next to each other to facilitate simple color synchronization
when desired. All switches
when desired. All switches must be operated at the same time to assure color synchronization must be operated at the same time to assure color synchronization otherwise the otherwise the
lights will work independently of each other. lights will work independently of each other.
5.1 Wiring to an AquaLink ® RS Control System
The Jandy Pool and Spa Lights can be wired into the Jandy AquaLink RS control system to ensure
simpli fi ed operation of the lights, as well as a means to synchronize the color change function. Connect the
lights to one of the auxiliary relays in the Power Center.
NOTE It is recommended to connect one light per relay so each light can be controlled separately. However, up to
four lights can be connected on a single relay. If there are more than four lights installed on one AquaLink RS
system, ensure there is more than one auxiliary relay available in the Power Center.
Refer to Figures 3 and 4 to connect the Jandy Pool and Spa Lights to the Power Center.
GFCI
Black
White
Green
120V
Jandy
Light
Ground
Ground
Neutral
120 VAC
Power Supply
Figure 3. 120-Volt Jandy Pool and Spa Light Wiring Diagram
CAUTION
A Ground Fault Circuit Interrupter (GFCI) must be provided in this circuit. The conductors on the load
side of the GFCI circuit shall not occupy conduit, boxes, or enclosures containing other conductors
unless the additional conductors are also protected by a GFCI. Refer to local codes for complete details.