Jandy JandyColors JPL120100, Инструкция по установке и эксплуатации

Страница: 13 / 20

Page 13
Section 6. Jandy Pool Light and Jandy Spa Light Operating Instructions
6.1 To Operate the Light
Turn the light ON . The fi rst time the light is turned on, the color change sequence begins with the
Alpine White color set and then continues through the sequence. The light cycles through 10 color set
changes. Each color set is active for approximately 20 seconds before the light transitions to the next color
(see Table 1).
Table 1. Pool and Spa Lights Color Change Sequence
Sequence Order Color Set (Consists of Two Colors in Each Light)
1 Alpine White (first cycle only)
2 Sky Blue
3 Cobalt Blue
4 Caribbean Blue
5 Spring Green
6 Emerald Green
7 Emerald Rose
8 Magenta
9 Garnet Red
10 Violet (color remains active approximately 4 minutes)
NOTE When the light is first turned on, the sequence ends at Violet and at the next rotation, starts at Sky Blue.
Alpine White is not included in subsequent cycles.
When the light is turned off, it will remain in the color set that is currently active. When the light is turned
back on, the color change sequence will start with the color set that was last active. For example, if the light
is turned off when Cobalt Blue color set is active, then Cobalt Blue will be the first color set in the change
sequence when the light is turned on again.
6.2 To Lock On a Speci fi c Color Set
Wait until the desired color is ON during the fi rst cycle of color change . Turn the light OFF, wait 2seconds
and then turn the light back ON. Wait 10 seconds before turning the light off so that the color will not reset.
NOTE If a specific color is not locked on during first cycle of colors, the light will continue to follow the color change
sequence. To choose a color
after the first cycle, the light must be reset.
If you encounter a dimmed light, the light was probably turned off during in the middle of the color transition.
To resolve this situation, turn the light off for 3 seconds, then turn it back on. The light will return to full power.
6.3 To Initiate a New Cycle or Reset from a Locked Color
Turn the light OFF, wait 2 seconds, then turn ON, wait 2 seconds, then turn OFF, wait 2 seconds, and then
turn ON again. The light will return to beginning of the color cycle (Alpine White) and continue with the
normal light sequence (see Table 1 in Section 6.1).
NOTE To synchronize colors on multiple Jandy Pool and Spa Light systems wired to separate switches, perform
the above actions on all of their switches simultaneously. All Jandy Digital Pool and Spa Lights will
synchronize automatically if activated off of the same switch. No other accessories are required.