USER’S MANUAL
18
OPERATION
5.2 FRONT PANEL CONTROLS
5.2.1 POWER ON/ OFF SWITCH(located in rear panel)
After the connection of power adaptor and other devices(HDDS) with this DVR, turn the power on.
a. The video signal system (NTSC or PAL) is automatically
detected.
b. Power Failure Recovery
This DVR automatically reverts back to programmed
record parameters upon power restoration.
c. If the power key is protected by password, the power off
cannot be executed before input the correct password.
(Refer to the PASSWORD in the SYSTEM menu,P70).
5.2.2 SCREEN DISPLAY
5.2.2.1 Multi-Display & Full Screen display
A
. Multi display
The example is displayed by 16CH DVR
To change a single camera display to the multi camera, press the MULTI button.
B
. Full screen display
Press the desired camera number button to display on the monitor.
•
If there is no video signal, the video signal system is set to NTSC. Do not input the PAL type video signal or it may
cause the DVR’s malfunction. In this case, turn off and on again.
NOTE:
-Use the +10 Button when you select two digit camera numbers.
EX) Camera Number 12 = Press the +10 Button, and then press the No. 2 Button.
-CAMERA/NUMBER INPUT buttons are used to input the password in the password lock function as well.