Barcode Scanning
XT200
User Manual
Janam Technologies LLC Version 2, April 2020
Barcode Scanning 9—2
Scan Settings
Go to
Tools
>
Scan Settings
to configure the XT200’s scan
engine and software. This is
where you set how the scan-
ner will work, how it will an-
nounce and communicate re-
sults, what all the scan
operation settings should be
and, most importantly, which
of the numerous code sym-
bologies the scanner should
read.
Tab Section Option
Description
Basic
Scanning
Trigger timeout (sec)
Specifies the trigger time out in seconds. If a
barcode is not decoded within the specified
timeout, the default Notifier indicates that
decoding is failed.
Enable Auto Scan
Enable Auto Scan with specified interval.
Auto Scan interval
Set Auto Scan interval time.
Enable Cont. Scan
Enable Continuous Scan without any interval.
Enable TouchScan
Brings up scan touch button.
Wedge mode
Result Type
Select Result Type:
User Message, Keyboard Event (default)
Clipboard, Intent Broadcast
Terminator
Select the desired barcode end method from the
pull down list.
Values: None, Space, Tab, LF, Tab & LF
Custom intent
Selectable events
Can be part of a datawedge profile.
Options
Options
Enable Center Window Set enable/disable plays audio sound.
Decode Mode
Standard or Quick Omni.
Decoding Delay
Delay decoding up to 1 second.
Inverse 1D mode
Reade regular or inverse or do autodetect.
Power Save Mode
On or off.
Enable aimer
On or off.
Enable illumination
On or off.
Notification
Beep
Enable Beep
Set enable/disable plays audio sound.
Media Volume
Slider to set volume
Good/bad read
Set sound to indicate good/bad read.
LED
Enable LED
Set enable/disable visual scan indicators.
Vibrator
Enable Vibrator
Set enable/disable vibrator operation.
Good read
Set vibration time after good read.
Bad read
Set vibration time after bad read.
Wedge
Barcode ID
Transmit Barcode ID
Enable to transmit predefined barcode ID.
Transmit AIM ID
Enable to transmit predefined AIM ID.
Group separator
Set to one of 30 codes (default is GS).
Label
Prefix
Prefix sent prior to the decoded/received data.
Suffix
Suffix to be sent after decoded/received data.
Character set
Charset
Select one of 14 character sets.
Extend. wedge
Enable
Toggle to select extended wedge.
Configuration
Allows configuration and adding of styles
Symbologies
Select barcode types you want to read
There is “Enable All” and “Disable All” to enable/disable all symbologies
About
Scanner
Show scanner type and software revision
Data
Factory reset
Restore scan settings to default.