XM70
User Manual
2-2
Janam Technologies LLC
Attaching the Handstrap
To attach the handstrap:
1.
Align the two holes in the metal handstrap anchor at the two handstrap screw ports.
2.
For each side, place one of the screws provided into a lined up screw hole/screw port and turn
clockwise. Secure both sides before fully tightening down the screws.
3.
Separate velcro to extend the handstrap and feed loose end through the handstrap bar.
Fasten velcro together to close the strap. Fit strap and secure device to user’s hand by
adjusting velcro as needed.
Installing/Charging the Battery
IMPORTANT Battery Warning!
CAUTION:
Use only Janam-approved batteries.
There is the risk of explosion if battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions.
1. To access the battery compartment, turn the
locking-screw counterclockwise
to open
the latch and remove
battery cover
.
2. Position the
battery lift strap
against the back of battery well, ensuring tab extension is on
left side.
3. Place a
Janam Lithium-ion rechargeable battery
in and snap into place.
4. Replace the
battery cover
by positioning the top prongs first and sliding into place. Tighten
locking screw
by turning clockwise.
To charge the battery using the USB Cable or Serial Cable:
1. Connect the
power supply
to the USB cable or serial cable.
2. Connect snap-on end of USB cable
or serial cable to bottom of XM70, making sure the word
TOP on the cable connector faces front.
3. Insert country-specific AC plug, and plug in the power supply.
4. The LED will illuminate to confirm connection (orange indicates charging, green indicates
fully charged and red indicates fault).
5. The battery is fully charged in approximately three hours.
To charge the battery using the Single-Slot or Four-Slot Cradle:
1. Connect the
power supply
to the cradle.
2. Connect the
line cord
to the appropriate power supply.
3. Plug in the
power supply
.
4. Insert the
XM70
into the cradle.
Note
: Proper insertion is required to ensure connection.
5. The LED will illuminate to confirm connection (orange indicates charging, green indicates
fully charged and red indicates fault).
6. The battery is fully charged in approximately three hours.
