Getting Started
XG3
User Manual
Janam Technologies LLC
2
―
2
Install the Battery
The XG3 mobile computer is shipped with the battery packaged separate from the unit. Follow the steps
below to install the battery.
1.
Remove the battery compartment door by moving the battery door’s metal locks to the up
position. With the locks in the up position, pull door away from device housing.
Insert the battery with the batteries flat surface facing down.
2.
Replace the battery door by inserting battery door tabs into guides near the handle, then press
down on the battery door locks.
☞
NOTE:
The battery door must be installed in order to power the device on.
WARNING: Use only Janam approved Li - Ion battery packs. Unauthorized batteries may result in
damage not covered by the warranty.
Changing the Main Battery Pack
Before removing a battery pack, press the Power key to put the terminal in Suspend Mode so that
operations are suspended before removing the main power source. Always put the terminal in Suspend
Mode prior to changing the battery.
☞
NOTE:
The battery door must be installed prior to booting the unit.
Charge the Batteries
The XG3 ships with only the main battery pack significantly charged. Charge the main battery pack with
the XG3 charging cable for a minimum of 4 or 6 hours before initial use.
Charging with DC Adaptor
a. Attach the appropriate plug adapter to the plug of the power cable.
b. Insert the plug into the appropriate power source. Plug the XG3 power cable into
the DC Jack at the bottom of the unit.
