JAMO S 250 HCS 21, Руководство по введению

Страница: 18 / 100

16
Troubleshooting
If the S VSR 25 appears to be faulty, first consult this troubleshooting guide before calling for service.
Refer also to the corresponding instructions in this manual.
WARNING
Under no circumstances should you attempt to repair the system yourself.
Symptom Possible cause Correction
No picture. • The TV can not show Progressive
Scan
• The TV is switched OFF.
• The TV is not connected correctly.
• Press “I/P SET” button on remote.
• Turn ON the TV.
• Connect the TV correctly.
Disc can’t be played. • The disc is placed upside down.
• The disc is empty or the format is
not supported by S VSR 25.
• The disc is dirty or defect.
• The disc is not placed within the disc
tray guide.
• Ensure the disc label is facing up.
• Remove the disc and try another.
• Clean the disc or dispose of it.
• Place the disk within the proper guide
on the disc tray.
No sound. • The VOLUME is set to 0.
• Speaker cords are not connected
correctly.
• Turn up the VOLUME.
• Connect them correctly.
The unit does
not respond to
commands from the
remote control. • No batteries are inserted in the
remote control.
• The batteries are worn out.
• The remote controller is not pointed
at the remote sensor of the S VSR 25.
• The remote controller is too far from
the S VSR 25.
• Insert new batteries.
• Replace with new batteries.
• Point the remote controller at the
remote sensor of the unit
• Operate the remote controller
within 5 m.
Power is not
supplied even
though the power
cable is connected. • The power plug is not securely
connected.
• The wall plug is not turned ON.
• Connect the power plug securely.
• Turn ON the wall plug.
The unit does
not respond to
some operating
commands during
playback • Operations may not be permitted by
the disc.
• Read the instructions on the disc.
Forgotten or
misplaced password. • Open disc tray
• Hold down “STOP” on the front panel
while holding down “TOP MENU” on
the remote. Be careful to point the
remote at the Remote Control Sensor
• The TV screen now displays software
version.
• Turn the S VSR 25 OFF on the front
panel and turn it ON again after 10
seconds.
• The password should now be reset