JAMAR Technologies TRAX I, Руководство пользователя

Страница: 25 / 64

NOTE: If you are collecting data with a four road tube layout
(L10 - L12) pressing the TAB key will switch you to the data for
your second channel. This will be reflected by the channel number
changing to 1 (CHNL 1).
The top line of this screen
gives you the date and time
as they are programmed in
the TRAX I. The second
line tells you the types of
data that have been pro-
grammed to be collected. The third line gives you the vehicle to-
tals for each channel for the current interval. The fourth line tells
you what interval is currently being recorded.
The top line of this screen
tells you the layout that has
been selected (L11), the
type of study being done
(Binned-Data) and that the
TRAX I is running, or re-
cording data (RUN). The next two lines represent the tubes that
data is being recorded on (A, B, C & D). As the tires from an axle
strike the tubes, an asterisk is recorded in the appropriate channel.
The bottom line tells you what number count this study is in the
TRAX I (CNT:02), the percentage of memory available
(MEM:99%) and the battery voltage.
The top two lines of this
screen tell you the layout
selected (L11) and how the
tubes should be arranged
for this study. The third
line tells you the distance
between vehicles that has been programmed into the TRAX I (DBV:
36.0) and the spacing of the tubes that has been programmed (8.0
ft). The fourth line tells you the dead time, or D-Bounce, that is
programmed (DT: 25ms) and the interval length that has been pro-
grammed (Intv: 15min).
2-17
TD 07:30:17 02/13/98
OPT= CLASS SPEED GAP
#V0: 02
#V1: 01
Interval: 0001
L11 BINNED-DATA RUN
A:****
C:****
B:** D:**
CNT: 02 MEM:99% 6.4v
L11: 2 (1/2 & full)
Tube Sets; A>C B>D
DBV: 36.0 SP: 8.0 ft
DT: 25ms
Intv: 15min
Chapter 2 — Operation of the TRAX I