Section E
……
cont
3. What to do if an Alarm sounds.
……
cont
iii. Check this reading against the ‘
System Map’
to locate the water
contact.
iv.
Attend to the reason giving rise to the Alarm.
v. If you
press
the button corresponding to the
‘Show Cable’
key,
The LCD Screen will change to the following & you will be able to view
the cable characteristics of the alarm:-
vi.
Press
the button corresponding to
‘Show Text’
to return to the
previous screen.
vii. After attending to the reason for the alarm, reset the system by
pressing
the ‘
RESET’
button. The LCD Screen will revert to Screen ‘A’
and the system will return to Normal Operation.
viii. Should the system re-alarm within 30 seconds & display the
same or similar Location Reading, this will indicate that the Detecting
cable has not dried or that the water is still present.
ix. If a vastly different Location Reading is displayed this will
indicate that a further water contact has been made.
x. Carry out the above procedures again until the LCD Screen
reverts to Screen ‘A’.
# NOTE – Following a Water Leak, the Detecting Cable should
be dried using a Clean Dry cloth. If the Detecting Cable is left to
dry of its own accord, ensure that an adequate air flow is
available to dry it. This could take up to 24 hours (depending on
the air flow available, temperature & extent of the water leak).
Contamination of Detecting Cable may occur after a water leak
(especially if it is allowed to dry of its own accord) if the floor area
- 11 -
VIEW
LOGS
SHOW
TEXT
TEST
OPEN CIRCUIT
LEAK DETECT
Leak at
……. METRES
